How do I make an action start at frame 0?

如何让动作从第0帧开始

Last updated: 2026-10-21

如何让动作从第0帧开始？

Set the action unit's seq range so it begins at frame 0. The seq format is part number followed by frame range, so the range must start with 0.

把动作单元的 seq 范围设为从第 0 帧开始。seq 格式为部件号加帧范围，范围必须以 0 开头。

1. Open the AG Action Group panel and bind the target material group.

1. 打开 AG 动作组面板，绑定目标材质组。

2. Add an action unit and set the target part (join).

2. 添加动作单元，设置目标部件（join）。

3. In the seq field, enter a range starting at 0, e.g. 01:0-5.

3. 在 seq 字段输入从 0 开始的范围，例如 01:0-5。

4. Or click "auto-suggest sequence" to generate a seq from the target part's available states, then confirm it starts at 0.

4. 或点击"自动建议序列"，按目标部件可用状态生成 seq，并确认从 0 开始。

5. Set relative rotation, scale, X/Y offset, swap part, or trigger event as needed.

5. 按需设置相对旋转、缩放、X/Y 偏移、换件或触发事件。

6. Open CANVAS to preview; drag to fine-tune dx/dy, edit rot/scale; changes sync back into the code.

6. 打开 CANVAS 预览，拖动微调 dx/dy，编辑 rot/scale，改动会同步回代码。

7. Click project validation and fix any red inputs before render.

7. 点击整项目校验，修正红色提示后再渲染。

CAN: start any action unit at frame 0; chain events and role tracks on top of it.
CANNOT: make a seq start at 0 if the material part has no state covering that frame — validation flags it.
Wrong range (e.g. starting at 6): the action leaves a blank gap at frames 0-5, and codec validation reports the mismatch.
Save the action to the LIBRARY to reuse it in one click.

Try it now in the 3SAX V3 creator tool.

现在就在 3SAX V3 创作工具里试一试。